Recent content by mikeinmilton

  1. M

    For Sale 2017 Land Cruiser 200 Overland Build

    Ghost truck
  2. M

    rear axle tabs - fabrication

    And I have a lead on a housing that is relatively close (2hrs away). waiting on some pics.
  3. M

    rear axle tabs - fabrication

    To be more precise, start up is 1,300 rpm which quickly goes down to 1100. When at idle and in gear, its about 800-900. Is that concerning?
  4. M

    rear axle tabs - fabrication

    First off, thanks for the replies. I was a bit frustrated with the initial responses from some but I should have expected such - as opinions are like assholes, everyone has one - some just have a****** opinions. I just picked this rig up back in May. Owner before me was a transplant from CO...
  5. M

    rear axle tabs - fabrication

    Thanks for offer, trying to resource one a bit more local.
  6. M

    rear axle tabs - fabrication

    I inly I only drive about 1/2 mile to train station. Got a little wobble to her.
  7. M

    rear axle tabs - fabrication

    Thanks, useful response.
  8. M

    rear axle tabs - fabrication

    Thanks Jeffro109
  9. M

    rear axle tabs - fabrication

    I will get more picks up in a day or two. But you west coast chicks with the pristine weather and no rust... best close your hole. I am asking for assistance to keep this truck going and not a ******* comedy skit. Put up something helpful or shut up. Isn't that the purpose of this forum? I am...
  10. M

    rear axle tabs - fabrication

    Yes, it was used solely to take a boat down the street and into saltwater for years and obviously didn't get a wash down. Rust is worst where it went in at boat ramp. It's been within 1/4 mile from ocean and NE winters its whole life.
  11. M

    rear axle tabs - fabrication

    mounts for sway bar and panhandle that is rusted out
  12. M

    rear axle tabs - fabrication

    control arm bracket that needs fabrication is below.
  13. M

    rear axle tabs - fabrication

    I need specs on the two tabs that hold the sway bar mount (driver side) and the control arm mount (passenger side) onto rear axle of '97 FZJ, floating with elockers if that make a difference. Thanks for the help
  14. M

    FZJ80

    tabs for control arm and sway bar have rusted off. Need dimensions to fabricate new or purchase if you already have them made up. Txs.
Back
Top Bottom