Got my Aisin fan clutch installed this weekend, took the LC for a couple 20 minute drives on the freeway, all is good. I may take the old fan clutch apart, just to check out, and get familiar with, if I decide to modify the new one.
So, I finally had some time to get back to the LC. I did notice that no coolant was pulled from the reservoir when I initially ran the car. This goes back to when I was topping off the reservoir when my radiator was leaking, the level had stopped dropping. The hose going into the reservoir was...
I’m wondering just how accurate my dash gauge really is. The engine itself is not showing any sign of overheating, like bubbling in the overflow tank or anything. I wish the coolant sensor on the block, was easier to get to.
So far I have replaced everything that “needed” to be replaced. The radiator was leaking. The hoses were old, as was the thermostat. After I replaced those parts and drove it around, I found the water pump leaking at the weep hole, so I then replaced it. The fan clutch is definitely the original...
Ok, my radiator was starting to weep, so I ordered a new Toyota radiator, and was topping off coolant. My wife was just using for dropping kids off at school, but she went a bit further and LC overheated. I had her shut it off when she called.
Replaced radiator, thermostat, hoses, and water...
Changed my belts today, could have been done in about forty minutes, but I did some extensive cleaning. There was a lot of gunk, from the residuals of my leaking power steering pump. (Which I swapped out several months ago).
So I’m going to order a new pump from Norwalk Toyota. The pump 44320-60182, o-ring 90301-73004, but the high pressure gasket 44327-30030, says it’s not the right part. Does anyone know the correct part # for a 94FZJ80? I would call, but I’m told I won’t get the same online pricing.
They are OEM. It’s seen a lot of city driving lately. I’ve been wanting to add some injection cleaner, so I picked up a bottle of the good “Redline” cleaner. I’ve been driving it on the highway all weekend. Initially I read the codes, then pulled the FI fuse to clear them. When I started the...