Recent content by MECA58

Interested, PM me..

I think SLEE makes a harness that switches them.

Kelly's grilles are very stout and the fit is spot on, no trimming required. I did have to cut the lip off of the horn bracket to rotate the passenger side horn 90 degrees to clear the grille mount. I also installed a nutsert in the center support to fasten the bottom grille mount. The grille...

Received my bumper last week, let me just say that build quality is top notch. My valance was bent so getting rid of it was a non issue. The DVS bumper matches the truck's lines perfectly especially with 'pocket ' flares. I installed it by myself (no winch yet) and getting it on and properly...

Webster77, did you relocate your steering and brake master cylinder!

Learned a lesson about helping a stranded driver when a Mitsubishi Eclipse stuffed itself into a snowbank and I stopped to offer a tow. I let the driver slither under his vehicle (in 2 feet of snow) to fasten the Bubba Rope, I hooked the other end to my 4x4Labs rear bumper and proceeded to give...

OME 861/862 stock height FZ80 springs, one year old. $200 plus shipping

OME 861/862 stock height springs for sale. One year old. $200 plus shipping

5 matte gunmetal

I welded a short piece of 2" receiver hitch to the base of my 4X4LABS jerry can basket attachment. I attach a Thule mountain bike rack to the receiver when needed. Open the swing out and the bikes swing completely out of the way. I just returned from a 1,500 mile trip to Nova Scotia without...

Spent a week exploring the Outer Banks, NC

Interested in the tank and dual filler neck. thanks

Two swing rear bumper welded no powder, tire holder kit, 3 can kit ordered and deposit paid. Thanks for putting this together ...

Interested in (1) side with strut and Molle panel.

Interested in dual swing out, tire carrier and gas can basket, welded, raw to 03860 NH. Thanks for putting this together.