Recent content by MacCruiser

Head gasket has not been touched. Birf Job Completed around 115,000

I have owned it for two years. I performed most maint myself. I have records for all work I have had done, but not the PO's records

$12,500 120,000 Miles Lockers CDL and 7 Pin Mod Slee cup holder 285/75 BFG ATs with less than 5,000 miles New OEM floor mats (will include original mats) HIR low beams from Daniel Stern Steps and mud flaps removed, but will include Will inlcude new (Uninstalled) Slee headlight harness and hand...

The vibration is not too bad. My brother in law also has a 97' 80 series and his rides without the same vibration at around 60 mph. The squeal did not start until I removed the drive shaft. I just put the drive shaft back on. I will let you know if the noise goes away.

yes, i have a cdl button installed. the abs and cdl lights are both on.

I removed my front drive shaft in an effort to figure out a vibration I was having at highway speeds. After I removed the front shaft I started to drive and now I am getting a bearing squeal starting at about 10 mph. Any ideas? I did not get out of the driveway because I was afraid I would...

Welcome and nice find. Isn't it great that so many people took good care of our Cruisers for us, just waiting on us to buy them? :) Tarbe, I found this one in your neck of the woods.

I moved up to 5 new 285/75 LTs. I wanted Revos but I could not find them within $200 of the BFG ATs. I purchased them at discount tire. I shopped around at several area stores, they had the lowest price and they matched a local shops price. They even threw in the replacement warranty for free...

Nice rig I am sure that is a rig my bro-in-law and I looked at. Was it on the North side of Charlotte? Anyway, Sweet rig @ a sweet price.

From one newbie to the next Hey, I just joined after purchasing a 97' LC in Nov. I am from Missouri and attended Mizzou. We can have a truce since this is neutral site. Good luck in the Tourney. I have you guys going to the sweet 16 in my bracket. Nice rig by the way. I purchased my 97' LC out...

The PO had the thing spotless(See below). I removed the Brush Guard and Tail Lamp Guards. The BFGs ride a little rougher (LTs). But I like the looks, and the steering is actually better b/c the Michelins were fairly old. I also removed the steps and mud flaps. I will ease into the mods (ya...

I replaced the stock Michelins with 285/75 BFG ATs. Added a CDL button and cupholder from Slee.

I guess I should introduce myself. I am from Charlotte, NC. I have been lurking for quite a while now. I have been a TLC fan for a long time. Purchased a locked 97' w/ 100,000 miles on it back in Nov.