Recent content by ltoy

Photos of the unit HI, Here are some photos of the dash area and the Top Located in Southern, NH My Zip is 03449

HI All, I got a 71 FJ40 that I am never gona do anything with to many other projects. Got the entire hard top Both doors (the bottoms are bad on both but the rest of the doors including the glass is still good) The entire dash Steering wheel / colume Hood Grill Both Front...

what effect does roll oversteer or understeer have? And how much is to much. I am playing with the number and I am having trouble keeping that axis level with my setup (I got 1 degree of oversteer in the back with the new numbers and 4 degrees in the front)

I was shooting for an As of 80% at ride height at both ends. I have adjusted the lenght of the uppers to keep the AS throughout the range of travel stable. I think ranges from 86 to 89 throughout the 14 inches of rear travel. Do you think I would benifit from even lower as number ( I was...

I made the mistake on my first 4 link to not make the mounts the same width as a Jonny Joint / Creaper Joint or hiem with spacers. Now I am redoing them all !!!

I would say the stock one is well up to the task unless you are going for crazy HP. My Take on the rear end gear ratio is: The lower the gear ratio the easier on Drive Train, Harder on Axle shafts. The Higher the Ratio the Harder on the drive train.

The Rockwell chuck wants to hit the Crank pulley. I could push the front forward more but I am shooting for a 118 wheel base. and I need the rear to stay where it is so the tires will not hit the body when in full turn at full stuff. On your rig did you change anyting but the slope of the...

Here is a screen shot of the front and rear 4 link numbers at ride height. 30 in the front vs 35 in the rear. And the Front would slope towards the rear end and the rear is flat. I am looking for Good stability while climbing under power and good manners in off camber situations. I plan on...

Hi All, I am building a new buggy (first one with 4 links front and rear) Been doing a ton of reading all over the Internet. I think I understand what I should be looking for for Anti-Squat Number. and I think I want a high Roll Center and a Flat Roll Axis. That Said I don't know if I can...