Recent content by lt1823

Are these studs longer than the original OEM studs? Thanks!

Is there anything that can be done with the charcoal canister check valve or anywhere else to mitigate the higher fuel pressures?

Thank you guys for your help, much appreciated

Thanks a lot, I appreciate it!

Do you happen to have a felpro part number for the flange gaskets at the cat?

Thank you all for the great advice, it is much appreciated. Do any of you know of any reputable shops that are experienced in LS3 swaps in FJ60s and are reasonable with their labor costs? I am fully aware that this is a huge investment and is going to take considerable time/money to complete. Im...

Thanks a lot for the heads up. I purchased those very studs and stover nuts from SOR. Would you recommend using loctite 271 on those?

Thanks a lot for the reply, I appreciate all info. Unfortunately I had leaks coming from just about everywhere - exhaust pipe flange, exhaust pipe original weld just before the flange, EGR pipe gasket, crack in J pipe flange weld (the weld essentially crumbling right off the pipe), at the heat...

Why did you have to replace the manifold gasket three times? And are you talking about the intake manifold gasket? I am getting ready to replace the egr pipe with the SOR pipe and a Remflex gasket, replace the exhaust pipe flange gasket, and possibly take it down to the manifold and replace the...

Has anyone tried 1 gallon of lacquer in the gas tank, gas tank 1/2 full, then driving ~150 miles and if so does this work? Is it dangerous for the engine? Thanks

Along with using the correct Locking exhaust style fasteners, do you recommend using like loctite 271 on the studs?

Did you have a hard time getting the SOR J Pipe to fit? Ive been hearing there will some vice grip manhandling involved. Any tips?

Getting read to drive from OH to OR so I hope I have the same experience haha

Sweeeeet! Looks good. Just ordered mine from SOR as well as the J Pipe :)

Haha Roger that. Appreciate the help. Just got the Felpro 60915 Exhaust pipe flange gasket from Autozone for like $5 and the hardware/studs/nuts from SOR. Do you recommend replacing the hardware with bolts for easier removal next time?