Recent content by landocalrissian

Mine came with nylon bolts that I was able to take into Ace Hardware and match to a stainless bolt. Don't remember the size. Did yours come with the nylon bolts?

I think it is engine dependent. The new Tacoma with the same hybrid engine loses 500 lbs of capacity compared to the non hybrid.

My Lseat drivers side wore through in about two years.

The rear wiper on my 2000 LC has an issue where it works in the "ON" position, but when I switch it to off the wiper will stop wherever it is at in its cycle instead of returning to the bottom of its arc. The intermittent setting also has an issue where it will go 3/4 of the way up and pause...

If I remember correctly you can get the turn on signal from the harness that you disconnected from the back of the original head unit. You don't have to get it from pin 1. It is probably the same color of wire at the old head unit harness as the pin 1 cable. Alternatively, you could splice a...

There are other ways to do this, but I followed the TLC FAQ website in my 2000. Here's a brief summary. 1. I used the metra harness that crutchfield suggested. All of the wires on this harness connect to the speaker outputs on your head unit. The other end of the harness will plug into the...

Bisque. As another data point. Here's what mine look like after 10 months. Both the driver and rarely used passenger seat are showing wear. They are going to send me some dye, but I was hoping they would hold up better than thjs.

I have the Nitro gas shocks withe OME 2865 in the rear and cranked OEM torsion bars. Great ride when empty. Fully loaded up with 2 kids, 2 dogs and roof top cargo box for camping and the 2865's start to sag a bit. Ride quality is still fine though. If I add my pop up camper to the mix the...

Mine had a set screw that when loosened allowed the mirror to come off the base that was attached to the windshield. From there I tightened two small screws on the base along with some blue loctite. It's been solid ever since then.

I bought this kit last year. Fast shipping. No complaints whatsoever.

I just had BlackFlameCustoms.com do mine. He is in Fort Collins. Tell him Adam with the Black Cruiser sent you.

Get another ethernet cable and stuff the large coupler up behind the hood release.

Probably. I was just hoping there was maybe something I overlooked and could take care of it with the wheel since I already have it torn apart.

I'm trying to install the Ebay steering wheel in my 2000 TLC, but can't get it aligned with the marks I made. When I can get the splines to line up and go on, it ends up a little too far left or too far right. In other words, I can't adjust the alignment one spline at a time. The original...

The bottom was recently coated. Lots of rust in the engine bay. Said they got ten calls on it the first day and then I noticed they raised the price by $500