Recent content by kuhyuan

Been getting p0440 code. I can clear it but will eventually come back in. Few weeks. look at the evap canister on the. 98 lx470 and noticed that there should be a hose connected to the canister looked for a loose hose but didn’t see It. Will need to look under the hood again tomorrow. any...

Just did the drivers side cv axel today followed the instructions, but took off the entire wheel assembly for easier removal I also tied a strap to outer part to level it out and used a brass punch and tapped It a few times to pop it out. It was surprisingly easy to remove. my inner boot...

getting ready to reboot a cv axel on a 99 lx470. New cv axel from Toyota is about $700 my question is ordered 04427-60121 which should be the kit for the OEM cv axel. I received 4 tubes of grease. so which grease do you use for inner and outer and do you use all four tubes? i am guessing...

It’s to Andy Le on Facebook group “Land Cruiser lexus lx470 100 series USA” he did a great job and was I able to remove the MC and install it in less than hour each time.

I just did the replacement. I sent it in to get it refurbished with a new motor $650 with shipping new ones are close to $1500. Most time it’s the electric motor that fails. i have never done this before. Saw a YouTube video with Timmy the toolman i would say about 3 hours total to remove...

I just did this project with the help of this great forum. taking apart the HVAC console was easy and also taking apart the circuit board. unsoldering and soldering was tough. Not my best talent. Was able to get the old switches out but getting the old solder out was the hardest. just be...

Just a update, it was a bad fuel pump. Not a Immobilizer issue. thanks for everyones help

I do remember the blinking light was on when I was trying to start the engine but another time it wasn’t on. Idk if it was doing it while I had the jumper wire attached. I’ll get my dad to help me when I try the jumper wire again, I did take out the EFI fuse when I did it the first time It’s...

Thanks for the help Also any chance that the crankshaft position sensor may have gone bad? That oem part is close to. $100 Don't want to waste money on parts that doesn't need replacing. Can't get any trouble codes on my code reader other than the P1600 after I did the F terminal bypass...

1999 kx470. 160K. Original owner cranks strong but will not start, the Immobilizer light blinks with the key in ignition. tried jumping battery positive to F terminal. Would not start, just cranks. Battery is strong and everything does work. No CEL lights. Was working fine and was parked...

Just did the high temp gasket maker and two clamps Took care of the problem and regain my sanity

Just saw you on I25 near Lincoln It’s immaculate and very nicely done

I also think its the apps/tps

Steering does feel a little more connected and in control . The old rack was almost 20 y.o. So the new rack should be firmer and gives you more confidence .

that is a great shipped price. After seeing the package and noticing the steering rack was already protruding out of the box, I think it was better to pick it up in person. Don’t want to get it damaged in shipping and having to return it. It’s pretty heavy.