Recent content by KollesoBrothers

I have done multiple times. And found alternate sensors not expensive, connect direct to TCM. and read from external ring https://photos.app.goo.gl/NDxgPt6FYzMaPtjt8

Sprinter/Crafter TCM adjusted to work on OM613 swap and abs with axles from Sprinter Working next for 7-speed for OM648 engine Crafter/Sprinter OM613 + 722.6 Kickdown Full throtle

Easist way is with automatic transmissio. I haven't adapter plates. Yes I can made ECU for manual shift. OM628 have two types of control unit , may be and one more. What your gear ratio and size of tires - calculate what you will have max RPM of CDI id 4500 and power below 4300. You need axles...

CAN-filters adjusting in local on project, to distance is difficult for you custom build. Do you have a page about your project? То know what you installed. You installed the dash???? and SAM??SAM is not needed

No problem is not in Pressure sensor. KLA panel with canbus via EIS must connected to engine. probably Fan is defected, or another power coded. CanEmulators - makes and programs for custom purpose. In your case, need just coding for ECU and flashing. Disable MAF, EGR.

For normal working of fan you need decode KLIMA, or install at CAN network KLIMA control panel, or simulate it with CAN EMULATOR/Filter ESP/BAS can remove by edit flash of ecu. We did it. Also can use Emulator/Filter can

On 203,210,202,Sprinter,vito flashes without removing changes program in 3 chips, adds some components. For immo places CAN-filter - not just emulator. And program in filter depends from needs. Stik transmission for 613, start command via CAN from new Sprinter or by analog wire......

To gearbox both fits, but flywheel fits, but impulse teeths for electronic control Not. If put without electronic IP it also fits. may be put 6.2-6.5 Detroit diesel from Chevy/Humvee ?? with transmission. May be also a put alisson 1000 6-speed with stand alone ecu.

Then i think you need 604 or 606 turbo engine

You have automatic transmition or stic mechanicle. May you need just flash a car with simple program - without EGR,MAF,Swirl and other stuff. I can give you this flash for it,also ypu can make immo off on it for no problem with it. 602 engine doen't is very good. 606 so,so they are too...

I researched TCM's from mercedes and can made EGS52 TCM in to G-wagen version, they works without ESP/ABS but need aditional speed sensor on out of transmission with 16 teeth.

What kind of transmission you will use? What purpose? Easiest way now is OM613 - they have immo solution and flash without MAF,EGR,Flaps and over limp and limits modes. OM648 in closer time we will put into RX-8. May soon work with flash on it. At now i have flash solution for...