Recent content by jpd motorsports

the crank sensor has an ohm range for them to be good Mine 1999 would run die run die. found the ohm specs and it was out of range. be something to check easily. also check the wiring to the sensor it could have gotten nicked or rubbed by the serpetine belt, same with cam sensor wires. under the...

i run 315s, lx470, AHC sensor lift for about an inch, splash shield heated re shaped, pinch weld mod, trimmed front bumper, and washer reservoir cover re shaped. stock wheels and spacers. Everything else is bone stock suspension wise

also check 4 Wheel Parts, our local store had sets in stock

Depending on budget, on the lower end surprisingly the smittybilt kinetic works quite well. For the other end I use Monster rigging and their soft shackles Monster Rigging - http://monsterrigging.com/ and I've used Bubba ropes before

I did the sensor lift. was a 10mm wrench, slid the sensor to the top of the slot. nothing special at all purchased. theis is a geat write up on here about the ahc sensor lift.

patagonia milestar mt 315/75/16s coming in today along with 1.5 spacers, and small AHC sensor lift along with typical pinch weld poundings. getting ready for TX bipolar weather this weekend/Monday

rack bushings is where i would look. My 99 was almost a half turn to get get input to actually start a turn. had the wife turn wheel while under and the rack was shifting before it engaged motion.

which state? See if anybody is close by to take a look at vehicle. also for vehicle inspection look at R8tr.com

full flush of AHC, brake fluid flush, grease job, rotated tires, checked brake pads, ball joints, etc while tires were off.

Anybody running Dexron instead of the ahc fluid? Pros? cons? Just need it to last a few months longer before it goes under the knife to change the suspension out...

I get my cabin filters from oriellys.

saw a thread on here where a person relocated their power steering reservoir to in front of the air intake box. might be something to look into.

Found Crank Sensor OHM specs. Cold1630-2740ohms, Hot 2065-3225ohms mine was batting 1000ish cold. changed sensor out and so far so good.

3rd wire looks to be a bare wire ( ground signal isolator? somebody might know it better. Its not connected at plug.) If you can strip back the green wire and make your splice on the 2 smaller ones, then re wrap the bare (3rd) wire around it like it is. You can use 2 separate wires for it.

possible vacuum leak? all those hoses going to the air box see if any have any cracks, splits, etc. possibly got a hairline in one. check the maf connector to see if pins are good and straight and reconnect. also might need to let it idle for a while for the computer to re learn idle. mine took...