Recent content by jdsalinger

  1. J

    west palm beach florida junkyard find

    F.y.i. The u pull and pay on benoist farms road has a 1996 land cruiser 80. Engine, tranny, front diff, dash, and most interior are already gone. Doors and fenders might be ok. Rear hatch was rusting on top. I have a 87 4 runner. No land cruiser (yet). I figured i would pass this long as i...
  2. J

    Machine shop recommendation South Florida

    Hi, We recently acquired a 1987 toyota 4runner that needs to have the engine (22re) rebuilt. I was wondering if anyone could recommend a machine shop in the Stuart or Port St. Lucie area of Florida? I am willing to drive to Miami or Broward County if necessary. Looking to do a stock rebuild...
  3. J

    Dead alternator

    Most auto parts stores can bench test an alternator free of charge. Test before throwing parts at it. I would imagine the fusible link could be tested with an ohm meter.
  4. J

    wheel bearing seal installation orientation

    I called Timken Bearing customer support and they also said that the coil spring side goes towards the bearing. Thanks for the quick reply.
  5. J

    wheel bearing seal installation orientation

    Newbie question. I am repacking the front wheel bearings on my 1993 toyota 4runner 2WD. When I removed the inner wheel bearing and seal I didn't pay attention to the orientation. The factory service manual isn't any help. Both sides of the seal have a rubber lip, but one side of the lip also...
  6. J

    parts gurus - Which parts are going to be NLA ??

    What about the venezuala 80s made until 2007? Do all countries in the world share the same supply of spare oem parts?
  7. J

    Anyone know where I can buy a new EGR?

    Does it have to be OEM? Autozone has one for $110. Part number EGR4001. It says it is compatible with OEM #25620-61120
  8. J

    Possible to rebuild '97 MAF connector?

    Did you use a special tool to crimp the new terminals? So far I have been lucky and haven't needed to replace any pins. The local dealer insisted on ordering the pigtail which turned out to be the wrong end of connector.:doh: I definitely got some attitude when I returned the next day armed...
  9. J

    Possible to rebuild '97 MAF connector?

    Small hint on Toyota wiring connectors. Most of the connectors have the last five digits of the part number on the connector. It is usually hidden in the most obscure place and difficult to read. I had to depin my fuel injector connectors to see the part number. My sixteen step son bought a 93...
Back
Top Bottom