Recent content by iqbal624

roof rack looks sexy! Couple questions. Assuming there’s going to be an option for front fairing with lightbar. 2. the bars seem to sit just a tad below the side rails. Will this be an issue for RTT’s that are wider than the side rails? 3. cost and lead time?

That’s awesome! will the lines match up to the 2015 front end too?

Wow! Bumpers look great. Two questions. 1. Any for the 2008-2015 body style? 2. Will the bumpers be airbag compliant/ tow rated?

I have a set but I’m all the way in Washington.

Any chance you have a write up of this?

Any updates on the roof rack? Even a sneak peak would be great. Trying to see how far forward it comes compared to the prinsu.

That’s meee!! Were you the one caravanning with me for a bit? :)

Just installed mine last night. I had the same camera issues as everyone else but i was parked in my driveway where i could get Wifi from my house. Updated firmware and software in about 5 min. All problems resolved. Rear Dvd works as expected too. No issues here but haven't done any longer term...

That's awesome. I'll look him up. Going to see if any Seattle locals have them first. :) Thank you!

Does anyone have any extra roof rack cross bars? (Or a gobi rack for sale) I’m taking a road trip down to Moab in about a month and understand that the factory rack should be able to support my RTT. However, I’d love a couple extra bars going across just to spread the load. It would be great...

There are no perches in the rear. the springs you use for the rear determine the lift.

17x8.5 +0 w/285/75/17

Finally got my suspension completed. 6112’s on the top perch (3”) with OME 2722’s in the rear (no rear seats or load in the back for now). I was stupid and didn’t take before measurements :(

Got the lift on. Ended up with Bilstein 6112/5160 on the top perch (3” lift) combo with 2722’s on the rear. Also installed OME UCA’s. installation took longer than anticipated but that’s how it always goes. Right? The rear is sitting up real high (no weight in the back and rear seats removed)...

How’d the install go?