Recent content by haveissues

Thanks, the measurement of the 2.5's is a big help. I didn't want to take the time to clean up and install mine only to find out I can't use them. Thanks again.

Ill take them. email sent.

I seem to remember reading some place that stock is 12" from the top of the axle to the bottom of the rubber bump stop.

I second the float type. My refrigeration dryer has one and it works fine. It is also the most simple.

I have had wheel bearings that made so much noise and vibration you would think the wheel is coming off any second. When I changed them, you couldn't even see the pits, only feel them with your finger nail. They would have went for a good while longer. I say replace them when they sound like...

I'll take 'em. PM sent.

Sorry $4000 is the best I can do. You obviously missed the "red" part to throw out such a low ball offer.

Mine are nicer and also red. Looks like I'm into BIG money :smokin:

That seems to be the harbor freight way. Either you get one that works or it is a complete POS. I adjusted the guide on mine and it cuts square now (after I fixed the hole that stripped out on the guide while I was tightening it). I didn't have an issue with it throwing blades. A bigger...

I say bandsaw all the way. I had a harbor freight abrasive chop saw and got tired of the noise and mess it makes. I bought the harbor freight horizontal band saw with a good blade and it works very well. A higher quality one would have been nice but it works well enough for the cost. It is...

Anyone have a set not on the truck they could measure?

Found a set. Thanks.

What kind of shape are the '73's in and what do you want for them. Thanks -Martin

I NEED 1 but would take 2 if the price is right and they are in good shape.

Hi, I'm looking for a front leaf spring mount for the front leaf for a 73 fj40. I think pre '80 will work? Thanks!