Recent content by hamm

Good bye Land Cruiser. I'll miss you!

$7000.

Closer but not there yet.

I'm not very good at managing emails, PM's, and all that so if you've contacted me and I haven't replied I apologize. To the fellow that asked if the frame was bent after the rollover I can say that it was a very low-speed tip over. Basically it just flopped over on a sandy road with almost no...

Okay. Mailbox is empty now. My wife said no FJ too but now she's the one who wants to keep it!

$7900 OBO.

1978 Toyota FJ-40 Landcruiser. Excellent original condition with a few upgrades. California born and raised then moved to Reno,Nevada. The Odometer shows 35k miles but I’m guessing it’s 135k. It has spent the better part of the last 20 years sitting in garages. The Good: It’s all original...

Sold!

They are gone!

I still have them but someone is coming to check them out this week. I'll get back with you.

I emptied the inbox so send me another PM. I'll try the NV Clubhouse too, thanks for the info.

I bought it at Cruiser Outfitters. The problem is it got installed when I first started the project 6 mos ago and it sat. I have no part number for you as all the original paperwork is gone.

1978 I'm happy to finally be able to claim it as a DD. I just spent a few months rebuilding the knuckles, steering, brakes, and suspension. Before that it was unsafe at any speed which limited it to doing a few easy off-road excursions and neighborhood cruising.

I have one brand new aftermarket wheel cylinder. I got the wrong one for my '78 and installed it before I realized it was wrong so I couldn't return it. It fits in the rear axle, driver's side, front position. 1 1/8" bore with the banjo bolt fitting and not the flare. The adjuster has right...

I just swapped these out of my '78, they are stock as far as I know. They seemed kinda flat because it rode about stock height with some extended length shackles. A bit rough riding too. These are free to whoever would come pick them up in Reno, NV. I don't want to bother shipping them...