Recent content by GreenLandCruiser

Nice to see you started your build thread. LC neighbors, haha

After 2 months of troubleshooting struggle, I think I finally found my electrical gremlin. I switched to LED turn signals back in August with the LED relay ( https://a.co/d/4lEWCWU ) and had 2 complains: 1. it is so much louder than the OEM one, 2. It made the blinker do "ghost" blinks, after...

I replaced the sway bar bushings (the ones mounted above the torsion bars) and the noise went away. The ones I had installed were about 4 months old 26mm poly and bought 27mm poly and pre lube them with regular grease during the install and noise went away. I guess the olders ones were too...

To get to see that play, you have the truck lifted off the ground ? And turning the steering wheel ? Or by hand ?

This is what "Bushing No.2" looks like new. https://cruiserteq.com/front-lower-control-arm-rear-bushing-fits-1998-2007-ifs-100-470-applications-susb48655/

Here is what I've done today: Lube all body mounts listed below with silicon spray lubricant.(no change to noise) some are really hard to reach the top part, however the noise is from the front of the truck and i was able to lube those easily. I then reached in deeper to inspect the front...

Do you know the location of all the body mounts ?

Just finished replacing the front lower and upper ball joints, I'm using adjustable SPC upper control arm and now need an alignment. The noise is still there. I did see some weird loose bushing for the front lower control arm rear bushing, the one in line with the torsion bar. I'm gonna do some...

I'm replacing the upper and lower ball joints. I replaced the sway bar end link bushing and didn't change anything yet.

That was my next place to put the gopro but it got dark. Also, wouldn't the bushing cause the noise to happened when I turn on either side ?

Around 1 week after replacing the sway bar bushing and end links I started experiencing a weird noise when turning right (yes, only right) on the driver side. I've captured some clips to try to see any weird movement and to capture the noise. I'm not sure if that noise is too loud to be the...

I'll definitely look that up. Thanks for the idea.

Wouldn't an ECU issue be permanent ?

After a little over a month of browsing for solution here and other forums, troubleshooting and throwing some parts at it I had to create a post to get new set of eyes and ideas on my issue. About a month ago my 1999 LC has been showing the ABS light when only when I turn (low speed ~10-15mph)...