Recent content by Goobmeister

I wont need a longer DS will I?

alright I m feeling a little better about this, so all i will need is a new seal and some new Oil

So guys, back to original question. IF i remove the drive shaft then the nut, do i need a new flange/crush sleeve. Or do all i need to order is a new seal?

I do not daily drive it, only when I'm driving to the trail. I'm running 35' on it and haven't noticed any rubbing in the back on the front of the fender, but to be honest i haven't paid it much attention. I've only been out to the trail twice since I've gotten it with the lift on. I think i...

New to some of the terms. What should i be looking for?

What should i be looking for in the Ujoints?

I put the 3'' OME lift on and corrected the caster in the front control arms, but havent done anything to the rear. Do i need adjustable rear control arms or what?

i havent seen any oil there.

On the rear drive shaft

It is leaking from where the Drive Shaft Connects to the Flange coming from the pumkin, the oil is then running down and pooling under the drain plug basically

Hello everyone, as you can see fro the title my rear pinion seal is leaking. Oil is running out where the drive shaft connects to the diff and its no small amount, but not to where I cant keep the level up. I have been searching the forums for ways to fix it and there are two drastically...

I got the bias. Was reluctant because of the flat spotting, but most of the reviews ive read say they do not much at all and after a mile or two they roll out

Thanks man!!

The previous owner has removed the flares so they wont be a problem. Do you think its enough lift, or is it not giving me much?

Ive gotten the 3'' OME lift from amazon that will be going in this weekend. That process will begin as soon as it hits 5 o'clock