Recent content by fzr400guy

Sounds good to me.

Done their yours. I will be back in town Friday so maybe we can set something up on the weekend.

Hey folks, I have a few parts that need to go. These will all be free to a good home. 1. Used factory radiator. Does need to be re-cored. 2. Factory right hand tire carrier off of a 1971 3. 1 pair of bumperettes 4. 1 OME medium leaf spring 5. 1 pair of roll cage mountable speakers 6. 1 19...

I have an @Awl_TEQ snorkel. These are the best quality units out there.

This is from Facebook. It would be pretty cool if we could get a decent turnout of 40's, 60's, 80's, and 100's....Just to offset all the jeeps that will probably show up. 4x4 Night Santee, CA 4x4 is starting the year NEW! With new comes change and with change comes a new location. We have...

This is from Facebook. It would be pretty cool if we could get a decent turnout of 40's, 60's, 80's, and 100's....Just to offset all the jeeps that will probably show up. 4x4 Night Santee, CA 4x4 is starting the year NEW! With new comes change and with change comes a new location. We have...

Welcome to 40 ownership. I'm in Lemon Grove so hit me up if you ever need help working on your 40. My 71 is a resto-mod with a 350 SBC but I'm pretty handy with basic motor stuff.

Installed a new starter 2 weeks ago on my small block 350, then had the 2nd MSD distributor (1st was a pro billet, and the 2nd was an E-Curve) within 3 years fail on me. So this time I replaced it with a HEI from Autozone.....Works like a charm and has a lifetime warranty. I'm really done with...

4 shot group

Magpul Hunter 700 stock in FDE

I would definitely just pull the carb and throw a reduild kit on it. Whatever you do don't replace it with an aftermarket carb (Edelbrock/Holley). I do have to admit that I am currently collecting parts for a TBI conversion. I'm done with carbs!!

A little late but I replaced my rear drive seal on my transfer case......Finally I have no oil leaks!!!!!