doseman's latest activity

Starting the build back process or atleast the "remove the damage" process. Youngest mancub and I started pulling pieces and parts off the ole girl this weekend. Cleaned her up a bit and took her for a quick ride just around the neighborhood...

I am going to take a lesson from Jesus and bring a cooler full of waters and pack a sawzall. I am really glad that you are okay, Allan. I was really concerned when I saw your Cruiser on the side and you were nowhere in site. What a relief when I...

Richard, good point for sure. Thank you and no offense taken. I made a mistake trying to “drive” through it and panicked when it started to roll back. I am very lucky I was not hurt.

Wasn’t sure if the water droplets on the hood was drool or rain.

I was doing some snooping. Clean.

Hospital parking lot in Woodbridge. Super clean.

Met a guy in VB today and checked out his rig. He's on the forum but not part of a chapter. Super sick with 80 axles underneath. He took me for a ride it was pretty epic. Motivation to get mine running for sure.

It was awesome seeing you get back on the horse that bucked you off and seeing you driving it out!!! BTDT. (on the horse, literally) It was also good seeing you later in the week, some people commented you actually looked younger later in the...

Allen I’m supper happy you didn’t get hurt. I feel it’s important enough that I have to say it so please don’t take offense. Equally important as wearing your seatbelt is listening to others that know the trail better and have more...

Well Retro went to SAS9 and did not fare well. Ended up on her side (flop!). On Monday of SAS9 took her up Mineral to Poughkeepsie to corkscrew. After the wall, which Retro cleared, had a mishap on the next obstacle and over she went...

I meant these😜

Group photo from the sky.

Waterfalls on Yankee boy

Let me clarify a bit more. While the install on the truck was straightforward etc the actual build of the bumper was a bit tricky. Not necessarily hard per se just that you have to figure all the parts and little pieces out. Setting it up and...

Bumper installed

Back to body work! Fenders looking better.

Planning on August 16th early morning until around 2-3pm getting as much done on the 62 as I can. I plan to focus on shifter linkage for the transmission, welding up some patches on the interior, and maybe routing coolant lines (or at least...

Camper

Saw this in a drawer the other day...

I am an authorized dealer for them. I really like them. We sell a lot of the HP M3's, the 770's, 771's and now the new AT 811.s as well as the MT 772. I like the Bias Treps, but they dig and throw stuff. Takes some HP to get them turning...

Take two? Getting gooseneck ready for trip out west. Going with Maxxis G load 14 ply trailer tires for piece of mind. Old tires have good tread but 8 years old.

I leave for SAS9 on the 1st of August. Might still have wet paint!😁 Hoping for a big push this weekend. Front springs and shocks all around.

I got the fenders welded out. I started to flap sand a little. Still a lot to go and I need to patch the pass fender. I do not like to weld sheet metal!

Rear arb locker installed and tested on rack. Will formally test in dirt when I get back home from working out of town. We made it a club tech day about 10 members showed up and most helped with cleaning and removing parts and pieces

FINALLY - GOT IT! Went over what felt like every inch of wiring, all connectors and finally found my problem. The swap harness has its own fusebox for and a key ECU circuit had a loose wire. How I did not spot this one of the first times I...