Recent content by Doable

.

Registered # 1087

Great time, really nice raffle prizes, good trails and great friends to hang out with! Thanks for the hard work that went into the putting on an event like this.

Very very nice !

Pretty cool event put on by another great Toyota club ! If yalls schedule is not full in June this event is put on at one of the best off-road parks that I have been to.

Will be nice to run into everyone again. We,ll bring over some sides.

Bump, A trip this great needs to be on our radar again, condo was great, people,food, trails , time went to fast. Something to think about for 2019 ? / 2020?

To much on my plate for this year but would be real interested for a run next year if there is room.

I little update to the build thread. Roof sliders worked out great ! Have noticed a lot of people that rebuild their 22RE are not happy with the outcome / verses money spent on the engine, mine in without a doubt tired so it time for a upgrade (there are a million choices here but this I feel...

Woo Hooo see yall in a few days !

The Champion Beadlocks balanced out really good I used air soft BB's , I used Josh's recipe for the amount to add AirSoft BB Tire Balancing - TTORA Forum . We rode a little over 400 miles in Utah and a little over 200 on the last camping trip with you and Davin with no death wobble or weird...

The pipe is .13 thick . The roof slider should also give me a place to attach tarp as a "poor boy canopy" :) If it works out Ryan it's all yours to copy ( let's just make sure it works 1st)

Thanks Razorback Land Cruisers club and BOD for all the work that went into the "Ramble" ALWAYS a good time with ya'll and this park!

Using 3/4" black pipe (water pipe) from Home Depoit. Since I'm not " running into" the trees just rubing / sliding against them it should work as planed. Goal was keep the weight up high light for trails yet still have protection.

After getting a little to close to the trees at SuperLift ORV park again I'm going to give a try at some roof sliders and see how the work out for hopefully saving glass on my hard top. This is the rough draft, still have to build the short spacer/ reinforcement that will fit between the round...