Recent content by dlong4109

Hello. Yep, it is still available. I did have it listed on eBay but now I’ve had two people use the buy it now and not pay for it. So I’m not sure I’m gonna put it back on eBay.

For sale is this 1984 FJ60 Toyota Landcruiser. The landcruiser has 293,000 total miles on it, but the V8 conversion only has 70,000 on the motor. It as a Goodwrench Chevy 350 V8 crate motor with an Edelbrock 600 CFM carburetor with manual choke. The starter has been replaced. The original...

Yes, it is still available

For sale is the pictured Original Factory Toyota Inclinometer. This is a rare accessory that was not an option for U.S. and Canadian Land Cruisers. It will fit any FJ60 from 1980-1991. Hand picked and imported from Australia. Extremely easy to install, fits in the blank cubby in the dash hole...

Sorry I didn't see this message. Yes, it is still for sale.

Is this shell still available? I just saw this post.

Is this still available?

For sale is the pictured Original Factory Toyota Inclinometer. This is a rare accessory that was not an option for U.S. and Canadian Land Cruisers. It will fit any FJ60 from 1980-1991. Hand picked and imported from Australia. Extremely easy to install, fits in the blank cubby in the dash hole...

I am looking for the body shell of a FJ60/62 basically from the engine firewall back and preferably with all the doors or at least from the rear doors back. The interior can be cleared. Frame off or on. Something like pictured just more complete like mentioned....

I am looking for the body shell of a FJ60/62 basically from the engine firewall back and preferably with all the doors or at least from the rear doors back. The interior can be cleared. Frame off or on. Something like pictured just more complete like mentioned....

I have a pair that I bought but never installed that I would be interest in selling.

Do you still have this cruiser?

For sale is a set of custom made FJ60 rear cargo side panels. I made a set of these for my cruiser and had enough material left over for a second set. These are made from 1/4" black plastic marine grade starboard. These were traced from the original rear panels from my 1985 FJ60. The rivet holes...

sorry, I didn't see your post. Here you go