Hi i have a redarc temp gauge that i want to connect to my auto can anyone share some info on the best way to connect the censor and in what spot will be the best . Thanks
Thanks iv got the same but the pins on the aftermarket switches dont match the the oem switches . They need to be wired differently. As the contacts on the oem swith and the contacts on the aftermarket switches are different . Thats where im stuck
Hi guys and girls i need some major help as iv gotten stuck on my last bit of work before all my interior can go back in. So here it is im wanting to install heated seats and i have the heat pads that go into the seats top and bottom , i also have the 2 genuine vertical seat heater switches that...
Ok thanks so much ill check that out when i get home from work and no i dont have a bracket witch explains why i couldnt find any matching holes . I did look at the brake and ecelerator peddle and did notice some threaded holes there but nothing matched the holes on the 2 tabs sticking out from...
Hi gang iv retro fitted the genuine cruise control to my cruiser and all went as planned after reading a whole lot on this site to get what i needed but im only stuck on 1 thing that i need help with . All is connected and works fine but my problem is i can not find the mounting place for the...
Thanks that is so clear now i understand. what im doing now is removing on the switch end pin 4 which is ground to location pin 2 slot witch is empty that will give me ground in the right location . Thats my first step... then i need to locate the power which is in the kick panel antenna...
So iv worked out the hazard part and all worked out perfect but this antenna thing i cant get going . I spent 2 evenings on it without luck. Any chance you can help me out on converting the wiring to make it work
Thanks alot that was a big big help .time to do some rewiring lol . Would you know where i can pick up the signal from for left and right indicators from as i also am wiring up a blind spot monitor and theres 2 wires i need to conect to the indicators?