Recent content by Darne

Rather than staking I use Loctite 640 Sleeve retainer on the spindles. After packing the wheel bearings I clean the inner races spindle surface with brake cleaner sprayed on a blue paper shop towel to remove as much wheel bearing grease as possible. Apply the loctite to the spindle, both...

Before it has cured distilled white vinegar will remove epoxy. After it's cured your peeling technique or abrasives, as mentioned. Learned this glass bedding rifles. Hope it helps, Dan

Ok, Thanks

Do you have a driver door latch assembly? Thanks, Dan

Is the driver door latch assembly available?

I bought the 69040-60031 through eBay from Dubai. I installed it. It does NOT function the same as 69040-60041. I removed the alarm years ago, so no fob. I unlock with the key from outside. That works. When I lock with the switch on the armrest it locks and won't close. I have to lock with the...

They do. I don't remember how much. Check this thread COMPILED - 80 Series Seat Swap Thread - https://forum.ih8mud.com/threads/compiled-80-series-seat-swap-thread.1031353/post-15319588

A lot better than the OEM. The sliders give a lot more leg room and the they are just bigger. the tall back rest really helped.

Corbeau Sport Seats. The fabric inserts are faded but no tears or stains. Mounted on 80 Series sliders. I had them in my 97. I upgraded to Scheel Mann. $250.00 I'm in South Phoenix. six 0 two five 5 zero 26 three five Thanks for looking, Dan

You could have a machine shop lathe turn the seal surface on the hub back to true.

The original Land Rover guys did as stated in the post above and painted with POR15, sanded smooth and another coat.

The neoprene sheets are pretty soft. They compress easily but "bounce back" quickly. I can't compare them to the original foam because it basically turned to dust when I started removing it. So far the neoprene has worked well. The 1/8" thickness replaces most of the original foam. There are a...

I used Neoprene self adhesive sheets I got from Amazon similar to this thread. reassembly of the A/C and heater / was alarming ATF puddle, heater questions and a cold day in NOVA and aircon ignorance (1 Viewer) The neoprene is much tougher than the foam. Hope this helps.

With it unplugged does the HVAC blower run? It looks like the HVAC Harness plug.

I got mine from Trail Taylor. They import from Australia and are a Vendor on this site. I got enough flat matching material to cover my drawer box too.