Installed a few of the XRC things on buddies heeps. Cant say that they arent stout. When you start messing with the compound angles to make that look right with your dimensions and fabbing mounts that hang her correct. ..... then painting, time, and hardware, and possible wiring....you basically...
@bigtreads She runs and drives just fine these pics are almost three yrs old. If you dont have the 6AL yet, save your money and go with 6A. The rev control can be set into FAST ecm. I went with a custom aluminum built by race shop in town, two rows of 1.25" dia tube that was flattened to ovals...
Understood LCW, just listing stuff that has worked or I have done before to get me to a point where I had more to work with than just problem itself. And yes baffles are sold, but if he wanted to do something today + cheaper than summit can deliver thats where its at.
Dude youre not being a...
One persons idea of loud or quiet is way different from anothers. Are there any good exhaust shops near you? There are a few here, but the ones that really want business have a good test setup for you to hear. I found that the 50 series was 3/4 noise of the 40, the delta baffle took a lot of the...
OK so low buck/tech is the key here.... lets start from base. Run it without thermostat and see if the temps are safe, enough for your comfort, to drive around get a base idea of where youre at.
If you need to adjust or dial in more, you can make a baffle from $2 stainless spatula from...
When you get your new ones in mic them and see just how much meat you have. They should be pretty beefy. Now check these out.... oilite bronze bushings Sleeve Bearings - Bearings - Grainger Industrial Supply
I use them in place of things that need direct contact, but still movement. You can...
I have never like pusher fans cooling anything I needed running for longer a pass or two in 1/4mile.
Running a F@&D Taurus fan with its shroud and two speed setup, ordered new one from rockauto and parts yard unit for backup. There is a small aluminum shroud box I made to seal gaps. Using a...
I ran this tank Gas Tank- FJ40- 9/72-12/78- FREE SENDING UNIT- CCOT Replica for years in two 40s without issues. Everything hooked up just fine and no leaks. Changed to conferr aux tank and a modified S10 tank when I went to V8s. If I were to do it again, I would do the S10 tank over the hassle...
383 SBC with FAST EFI 1.0 by Cruisertime posted Jan 7, 2016 at 11:46 AMParking lot with friends. by Cruisertime posted Jan 7, 2016 at 12:00 PMJK cab cover by Cruisertime posted Jan 10, 2016 at 4:40 AM
To keep the junk out, but still keep mounting surfaces for factory items. I ended up using old fenders and welding them in. Used a case of fender paint to really dead seal these to anything tires will kick up. Completely worth the time and effort.