Recent content by Coma1

My left rear window quit going up due to the switch.. It goes down fine. I pulled the door panel, unplugged the motor, used two short pieces of wire and jumper cables to the batt and ran it back up. I left the motor unplugged so my kids would run it back down until I can get a new switch...

Looking for a passenger side mirror assembly for 1995 80 series. Emerald green would be fantastic but other colors work too. Please PM if you have one. Thanks

Well, No... actually the questions are listed below. I've seen one or two posts that actually try to answer them without debate and prejudice :popcorn:

2 cruisers I've run across had the cdl switch installed into the dash, but not plugged in. I guess they were too lazy to dig the harness out??? Just something easy to check.

These pics are directly after replacing the doors and fender. I would take some today but its raining here. It looks about the same with a few additional scratches. You can sort of see in one pic where the top back corner of the drivers door doesn't line up just right. Again, it's no cream...

1993 FZJ80 NO LOCKERS 158,000 miles I bought this hit on the driver side with the intentions being a good, cheap, reliable DD + family camping/ hunting/ fishing rig. It has served that purpose perfectly. Pulled the B pillar and replaced doors and fender. Have been driving it...

Thanks!

Sorry for the hijack, but it may be relevant..... How does this work? I just bought my first cruiser last week (93' fzj80) and I'm in the learning curve stage. i've owned a bunch of EFI rigs and have never seen this. Most use a line pressure regulator and PWM at the injectors for...

In need of a drivers side front fender for a 93' FZJ80. New to cruisers, but it appears 1993 - 1997 would work. Feel free to school me on that... 38501 scottc at specializedindustry dot com Thanks

Drivers side fender still available? I just sent you an email.