Recent content by ClassicLCfan

I already have the external microphone, it helped a bit but there is distortion at the receiver's end during a call. Most probably due to bluetooth connectivity.

Looks awesome, I believe it fit right on to the place of the OEM head unit without the need of any adapters? Mine needed a special plastic box / adapter and it sticks out a bit and hides the oem clock. I may replace it after some time because I don't like the way it sticks out and also because...

Oh boy, lots of stuff during the past 2 to 3 months. Big dents on the wallet :frown: - New AC Compressor(s) - New Condenser(s) yes replaced both more than once. It was a mistake not to flush the system and replace valves in the first go. - Thorough cleaning of the complete AC system including...

Replaced the old stock springs which were sagging with King Springs KTRR70

The kick-down cable broke. Got it replaced with a new OEM cable. Also replaced the transmission strainer / filter.

Weekend Adventures in UAE XQuarry Offroad and Adventure Park Desert somewhere in Madam Area Pink Rock Dune

Steering box seal leaked during the recent drive in the desert. Got it replaced and the box serviced / cleaned.

Got this GCC 09/1999 FZJ100 last week. Yet to take it offroad, these are the only good photos I have at the moment

Just bought FZJ100 last week (09/1999). Observed some torque steer, replaced front lower arms, rear upper and lower link rod bushes, now drives fine. Left axle boot was leaking, replaced both left and right ones. The valve cover seal was busted and oil was leaking, replaced. New PS reservoir and...

some of the OEM parts collected back when restoration was ongoing (in 2019)

Bumping into an old thread. I just found out that the 24V BJ40 Clock Part Number is 83910-60020. Schematic below as copied from Megazip.net. Although it shows "Discontinued / Out of Stock"

The install turned out pretty well. Summers here are pretty harsh. And I had no insulation on the floor and firewall, yet it performed well for the front passenger and the driver. People in the rear cabin did not get much cooling. The driver side pod also helped at front. For the heater I got...

DIY jobs give such a satisfaction if you get the desired results. Did some Dash Pad Troubleshooting. Turned out to be better than I expected.

Thanks. It indeed does make a difference Joel. Interestingly, this tool was the first hub cap related part I bought, at least a year before I got the Hub Caps and Wheels 😂