Recent content by citric

I have the housing and chrome frame in good condition, but no lens. Anyone?

Thanks Mark! Got them this afternoon.

Title says it all.

I have lowered the cost to $10,000. This is a good truck that I am looking to move quickly. Here is the description I posted on eBay. Let me know if you are interested. Thanks, Brent 1973 Toyota FJ40 Land Cruiser - $10,000 Pumpkin Orange (rare original color) Over the last 5 years, this...

I posted my '73 FJ40 on eBay last night. I'd rather sell to a fellow mudder. I have a full description on eBay: Toyota: Land Cruiser I can pull the listing if anyone would like to deal directly. Let me know if you have any questions. Thanks, Brent

Just sold.

PTO winch off a '73 FJ40. Was attached to original 3spd. Was working prior to removal. $700. You pick up or cover shipping. This is a heavy beast! Located in Dallas, TX. I also have about 150' of brand new 5/16" (7x16) aircraft cable I'll toss in for an additional $75. I can send more...

Thanks all. algeebra and living are correct. You have to ground the actual shaft. I temporarily jumped it with copper wire to pass state safety inspection. It works for now. I think I'll replace the wire with a thin piece of strap metal eventually. Then it should be more durable given its location.

Thanks, algeeba! That's exactly the approach I was going to take. Wanted verification first.

I have a '73 that I have been working through horns issues on. I have all the contacts cleaned up and the buttons now trigger the horn, but only under one condition. It only works if I apply a ground to the nut holding the steering wheel on. Given that knowledge, should the steering shaft be...

Planning to reprint my truck this color. Is this dune beige?

Mid TN - PM sent

I have a 1973 FJ40 that I am going to part out as I am able to. Starting with the big stuff. This is off a truck I started to rebuild. Taking far more time than I have. Take far more money than I'm willing to spend to get it ready to drive. The engine was broken down, machined, and rebuilt...

Did you find a shop in the metroplex you were happy with?

Howdy all, I'm in the final stages of a rebuild of my 73' F engine. I'm to the point of putting the rocker arm assembly back on. Two of the push rods are elevated. What is the best approach for getting the rocker arm assembly on there and sitting flush? Should I back off the adjustment...