Yes I installed it and cut it based on pictures. I almost made the cut too wide at the opening at top back of the bumper because the cover almost doesn't cover the opening. If someone did provide measurements it would be great for future searchers.
My rotors look like that all the time but we see salt on the roads in the winter and I just assumed it was from that. I go "Cuban Style" on them like you did, hammer off the rust, run a file over it and reinstall. Easier in the back than the front so the fronts just get replaced with new. I've...
Hi, I have a 1997 80 series and a factory JDM winch on the way. Is there anyone that has a JDM bumper that would be willing to measure the width and height of the factory opening so that I can cut my bumper properly. Any help is appreciated. Thanks in advance.
I just rebuilt my oem starter with toyota parts. Took one evening to do it in the garage behind my house. Original parts lasted 23 years. Going on 3 years of daily driving after the rebuild. Sorry I can't help but to me it sounds like something other than your starter. Something that is affected...
The mechanical switch that is in the axle itself has been a source of electrical issues for me. From memory the same switch is used front, center and rear. If it were me I'd buy one just to have on hand and troubleshoot this first while it was being shipped.
Chris
Yes, rubber tip on an air gun, air pressure per FSM or if it didn't say just bring it up until it moves with a little snap to it. Most difficult thing was figuring out which hole to apply the air to but that wasn't very hard really.
One thing I should mention about this whole thing that I...
I replaced mine by just forcing it through after much time moving it around to try and get it through easily. One thing for sure you need to remove the spare tire.
I guess I should be more specific. There is nothing connected from the factory to the outside of the stop lever. It is something to be pushed with your hand. When you do push it the engine should stop. I am fairly certain I used mine to stop my engine once.
Sorry it has been too long I can't remember all the exact details but I can report that my fix from 2008 is still going strong with no codes sent since.
86337-60080 is what is in your truck based on the image. At least that is what it looks like to me. I have a 97 and when I replaced my antenna nylon cord it looked like your nylon cord.