Recent content by capperdog

Cleaned up the fuse block and replaced all fuses. I now have stop, tail, turn, running lights and headlights high and low beam.... And nice even voltage readings wherever I check! Thanks for the help gents! Now I have to figure out the wiper setup and see if the motor is any good. Any hints...

Thanks for the heads up and schematics.... Badly needed!

Sounds like you're on to something here. I plan to clean the fuse block and replace all of the fuses next weekend. I agree that it may have voltage but cannot carry the current necessary due to bad connection, faulty fuse etc. I was getting varying voltages as well, so the fuse block is the next...

Great thanks! At least I know at this point it all is connected correctly and what all of the wires are. That was a big mystery and messin with my mind! I will check the resistance from GL back to GL at the flasher. I am also going to clean up and re-install all new fuses at the block. That...

No problem on the reply and ideas boiling down to a worn out flasher. Problem is the flasher is brand new and works perfectly with the Hazard switch. Can you explain why/how when the hazard flasher is engaged the voltage on GL at the Hazard is 2-3 volts, so are the GB and GY going out that...

Thought I had found an issue. I had lost 12 V at the flasher and switch with the key on. Problem was at the fuse block. I need to clean that up to stop any other headaches from popping up. In the meantime I seem to have everything wired accordingly. Only the GY, GB and GL attach to the...

Kewl... Now we know exactly what the extra wires are! Thanks for that! I did hook 12 V directly to the wires at the connector and the turn signal both left and right do light.

Yes I saw this diagram somewhere else last night. You see that the turn signal switch is only shown with the G\B Left, G\Y Right and G\L power from flasher. No other wires show at that switch and the other wire colors are not listed. This makes perfect sense, as those should be the only wires...

Correction on the Right turn In circuit is G\Y, G\Blue, G\O. Out of the circuit is G\W and G NOT G\O

Well... Not one that is of any help at this point. I don't have a Haynes yet and the Body and Chassis for the 77 is on back order. If you can post one that would be great!

I am measuring voltage at the G\Blue wire directly to ground. I have 12 volts with the key on, but immediately drops to 0 when connected to any load. The other wires in the turn signal switch are: G G\W G\O G\R = Horn When in a left turn configuration, these wires are in the circuit...

Hoping to get some help..... Hi, I just registered after reading this post. I have an almost identical issue as this original post. Difference is my hazards work fine. I have ran all the checks listed here, but my turn signals left or right will not work. I have a new turn signal switch and I...