Long time since been on ih8 or Pirate. Building a 45 for my myself to end up my sons in a couple years. I knew checking your build Justin wouldn’t disappoint.
So what’s the colour & paint code ?
Love it mate
brooksy
Mick from Superior actually said right at the start the OE step was not a slider & only a step to help get into vehicle.
Superior build quality products & 4mm plate is probably a good compromise between weight & strength. We have 5mm plate available in Australia & if I had to be a little...
How come it cost you so much. I use race spec DOM tubing, brushed stainless & 1/4"- 5/16" plate & I would barely reach $400. I then sell them for approx $900. Price of materials in USA can't be that expensive is it ?
Brooksy
Well I am back home for a week after working away for the past month. Finally got to drive our 200 & after dropping the wife to work I dropped into a local Ironman dealership & got a quote just to pass a bit of time. $1,410 with Constant front coils & Performance rear. Fitting was $110/hr with...
Been a member for many years with building 40's & custom gear, barwork, cages & buggies but this is my first 200.
To say I'm happy & excited is an understatement but the only downfall is I work away for a month at a time & this will be my wife's daily & our family tourer & tow rig for comp...
Landcruiser 200 Series 2012+ Suspension Kit - Performance with Foam Cell Pro Shocks - See more at: http://www.ironman4x4.com/products/suspension-kits/suspension/landcruiser-200-series-2012-suspension-kit-performance-with-foam-cell-pro-shocks#sthash.1V3GwND6.dpuf
This the kit available here in...
Brian, I'm in Australia & about to buy a 200 (for the wife). Since we don't have any Tundras is it possible for you to do up a kit with all that is required for me to achieve what you have with yours & send over to Australia so I can fit it all up including shocks
Brooksy
Welding out this & my cage today. Just got to do roof bars in mine.
Going to be a painfull day though as the drill grabbed yesterday BAD while notching & I have twisted my thumb back, struggled to hold a toothbrush this morning so holding a welder all day is going to suck !!:crybaby:
brooksy
Sorry for being so late on the subject but here are some pics of a friends 40 I built & at the bottom of the page it has the tie-ins with bushings at the chassis points. Previous pages should have the cage build-up pics I think if you want to look for incab ties. Has pics of cage out of body...