Recent content by brian64

yeah, I know. the manufacture date says 12/77....not sure why it has some components of a 79+

78 Fj40 project vehicle WI **sold** vehicle has been sold. thanks to all who inquired Brian 78 FJ40 located 30mi west of Milwaukee zip 53118 vehicle has sat for a few years, started recently but ran rough normal rust for FJ40's, rear quarters, sills, under doors front frame rail bent due...

I have a SBC conversion (w/ rear crossmember bolted to rear of t/c) installed by the PO in my 40. Has anyone has a problem with these (fatigue or structural failures, etc.)? Just trying to determine the strength and longevity of the part. Thanks, Brian

Advance Adapters conversion bellhousing Where are you located? I'll take 1st dibs on it if your relatively close to me. I need to change my 3-speed to a 4-speed tranny/transfer I have sitting on the shop floor(the 350 is already installed). Brian

I'm in! :D

Thanks for the info. I found another body panel supplier while searching, http://www.canadacruisers.com/main.htm. Does anyone have any experience with this company?

I have two. A '64 that is in pretty good shape, and a '78 with some rot that needs to be taken care of. Thanks for the welcome. Brian

does anyone know of a bodywork supplier that has cheaper prices that CCOT? I need rear quarters, rear sill, and a few other pieces.