Recent content by barukinzs

Inyo Mountains

MT mountains

Nice rig and area! What light bar do you have on the bumper?

This is a used but still in good condition Conterra medical bag. Very durable and can be used for large range bag, vehicle survival BOB, take down rifle bag, or a large medical bag as it was designed. I bought it used from a SAR/Fire so it does have BLS written on it. I carried it in my vehicle...

Does that mean you'll have a set to sell? ;)

Thank you all for your input. All good points here! I just wanna make sure I/m not over thinking this

Both makes a quality dual air compressor mount. The Slee mounts have me a little worried placing that heavy dual compressor so close to the brake assembly/lines on vehicle that sees a lot of vibration off-road. Sdhq mounts to the passenger side. Which one did you choose?

Thanks! Material specs: DOM 1.75”/ .120 steel tube

Quarter inch Aluminum

I almost gave up the idea and just get a mass produced sliders but how boring is that! The devil is in the details, a lot of back and forth thoughtful discussion and we think we hit a home run on this one! 💯

I finally got a chance to test fit the sliders today. Looking at the photo, it doesn’t seem complicated but there was a lot of back and forth thoughtful discussion on the mounting design. Finishing up the light tabs and off to powder coating

I just followed the contour to my liking. Look closely to where it starts to curve and just follow the line. This took some detail work, making sure it matches the other side. .

not mine but curious why not

Removing the running boards is straight forward. Remove the splash guard then mark guide lines for the cut. I recommend using utility knife for a clean cut. Once you're done with cutting, unbolt the supporting legs, then start popping the rocker panel tabs that hold the running board.