Recent content by BadMech

Quick update. I pulled the camshaft position sensor off and inspected it. It's sitting here next to me at the moment. The wires all look good to go. I don't see any fraying or exposed copper. I tested resistance on it with a multimeter and it's reading 1.105 - 1.106 kohms. Is that within spec...

And, now that I reviewed the pages @IndroCruise mentioned, I definitely found the right connector for the sensor and saw where the wire feeds through the grommet into the LH TB cover. The wires exposed that I see look okay, but I'm wondering if something under the cover could have gotten damaged...

@IndroCruise Invaluable resource! Thank you! I think I found the sensor and the wires looked okay to me. But I'll go as far as to remove it and test it out even and fully inspect all the cables later. Meanwhile, while I was out there under the hood, and before my hands completely froze off in...

@flintknapper Thanks for that suggestion. I'll definitely check that out more closely today. Does anyone have a picture of where the cam shaft position sensor is? I believe it's somewhere on the front of the engine block closer to the driver's side (code indicates Bank 1), but was looking a bit...

Yo, yo, yo! I recently became an LC 100 owner. This is the first time in many years, I've owned a vehicle that isn't close to new. And it's already turning into an adventure. This forum btw, has been an awesome resource for learning about the land cruiser. So thanks to everyone here who...