Recent content by atoyot

bump! Still have it, running better after I tweaked the carb, but still needs a complete tune-up with de-smog.

That's mine! $1300

Still have it "clean 4wd". Send me a message or give a call if you need more info.

It's the second spring down from the top on the front. Measures about 43" long X 2 3/4" wide

FJ60 Spokane WA--$1300 I will consider trading for a small running Japanese made car. -Pink Slip in hand -No smog required! -1982 -FJ60 -4WD (four wheel drive) -2F Toyota Engine -240k miles -4 speed manual transmission ------------ --Needs-- Front leaf spring replaced...

Still selling this old truck. Just noticed a front leaf is broke. Does anyone have a spare, or know of a local that repairs old leaf packs? I will probably just sell it as is with the broke spring.

Sorry, I'm tripping. It's an original 4 speed. I assume its the original transmission and transfer case. No problems shifting.

Spokane Wa. (Sorry!) Rust behind rear wheel wells. I was told that was common area. That's the worst. I will get pics later. Interior is very rough. It would need new upholstery and carpet if that was important to someone. If someone had the time and ability, hey could have a good running...

Spokane FJ60 '82 Mechanics Special --Spokane WA-- I bought this Land Cruiser hoping to fix it up. Didn't do that. -1982 -FJ60 -2F -240k -4 speed transmission -New Rotors Last year -New Cap, Plugs, Wires, Fuel Filter -------------- -interior is rough. Holes in some seats...

I know there is a classified section, but I thought it would be kind to give the local club first "dibs". I bought this Landcruiser hoping to fix it up. -1982 -FJ60 -2F -240k miles -4 speed ------------ ---Needs-- Tune-Up De-Smog completed Brakes Bled ---------- Sometimes gets hot in...

I believe the air rail is already removed. I just need to get rid of the EGR cooler and that pipe coming from the exhaust area that sounds like a can full of loose metal.

Can these parts be removed? The two pipes. Is that an oil cooler? And I believe the other attaches to the exhaust or cat.

Drivers side and fender-well.

Please let me know if you see anything wonky. I'd like to get rid of as many parts as possible without lessening the vehicles capability. This is a bit of a crash course for me since I'm short on time, money and patience! Thanks Greg! :beer: (I took it out for a drive. It is running...

I did a quick desmog because the engine was running a little rough and I had just bought the vehicle. I left off the HAC for now. I only have one good BVSV and that is the lower one. The upper is plugged. The lower currently has one I have read quite a bit and used the de smog guide as well...