Recent content by 97LandCruser

im selling my car runs great my daily driver but i have to sell $7000 o.b.o Just make an offer!! i recently drove it from washington state to texas. very reliable. it is still not complete i had plans for 6" lift kit etc. here is my link to the thread anymore info? just ask unfortunately i am...

it has been along while but at the time i decided to use fj60 tcase i tried to sell the trans and tcase from my 97 no one wanted except if far away then i tried giving it away and no one jumped on it.then i got tired of holding on to it. so i threw it away. this was in 2013. sucks because i...

you can buy a diesel version imported from japan oem. not 97 of course but 90. 7 more years for the 97

i checked out a toyota sienna brake booster but was not the same. i am going to check one that is with skid control if there is any difference. i checked a 2000 2001 sienna. same shape but no skid control and the master cylinder mount only had 2 studs. my land cruiser one has 4 studs for master cyl.

what year sienna? and are all fj80 and fzj80 brake boosters same? is the check valve built in on the sienna booster or does an inline one have to be put it? thanks i have been trying to cross reference brake boosters as mine just started hissing

finally got around to calculating the receipts for gas when i did the long drive. i am missing 2 receipts. one didnt print on the way. and the last one which has city driving when i arrived. but i averaged 20.03 mile per gallon. hwy driving. could be a little higher but i did some city driving...

I moved and drove my land cruiser over 2100 miles. and it made it with minor issues. was a very long drive but i noticed the factory leather seats are uncomfortable. i did hook the cruise control and that worked well. it was make shift buttons but looked decent. I will later wire it into the...

i recently found out a possible cause to my gas mileage being low. I recently had a CEL P0171, P0174. but with the radio off i was pressing the brake and noticed if i push closer to the floor that there is a vacuum leak. looked on here and it seems to correlate to power brake booster going bad...

no longer available

what is your budget? 140 (110v) to 180 (220v) amp mig may be the best for starting out.. 180 or higher you can weld thick metal in 1 pass as the lower you will have to do multiple passes and maybe have to pre-heat the metal. i started off with a 130 amp mig cost about 500-600 with tank...

my problem is with the trans where the valve body sits it is in the way of the drive line. i am also using the fj60 tcase and i think that brings it closer to midline.. for me to correct this on mine i will have to raise the suspension so the front DS will be at more ecline to clear those...

nice.. i it is quite and easy install except for the front drive shaft. though i did the same swap but used a fj60 tcase. the engine is great and has lots of power and torque. i like it. since you are using the fj80 tcase it is easy to line up the trans mount to mount the engine mounts. Here is...

still have the a/c compressor, cruise control actuator, and starter. anybody need them. make an offer for all 3 parts. i would like to get rid of them asap.

I just removed mine rubber channels and scrubbed with warm water. then i used gummi pflege and coated the channels that come in contact with the window. after a few coats and dry i put them back in .. they work much better and it is still cold out side. not sure if the gummi pflege worked but im...

TicoCafe where did you get the key for the remote. is it something that could be purchased separately? i want to have the key in the remote. i can dremel it to fit. but i would rather buy one. thanks i would like to possibly get a remote start module to work with that alarm.