steffan

Too funny - I should be embarrassed or maybe that shows how rare they are? In the 15 years I’ve been reading this section,I don’t remember having seen those

A few months ago I purchased the headliner from Cruiser Corps. Am happy to report it has been installed...

Dave has supported GSMTR off and on for years! Support 4plus! A small business that supports us!

4Plus tire carrier is probably the upgrade that has made the most difference in my 40. Incredible build quality and easy install.

OK, I'll be the one to ask - what are those doors?

Check out the gas tank well, has 2 hole in front of the shifter??? I removed tons of bolts and only one broke in the trans tunnel amazed how they look new in the threads. Paint is cherry under dash pad. Check out the baby Swampers, 28x8.50x15...

Quick mock up. They look pretty good. Need to let the paint cure a bit before getting them mounted.

if I remember correctly, there have been a few on here that have done that at home with simple, easily accessible equipment. it was slow and a lot of work but the results looked great

Made brake lines for the first time. Hopefully they survive the leak test.

We drove to a waterfall just outside of Bogota. Lots of twisties , turns, low and high elevation. The Land Cruiser ran flawlessly. We had a great lunch (menu del dia) at a roadside restaurant. The weather held up well, as we were expected to get...

Love the City Racer - purchase quite a bit from him and have always been very happy

how it mounted in the box. some high density foam to keep the accessories from rattling

the finished product after painting it with some spray can bed liner. some light foam on one side just because (not really needed)

Just wanted to throw this out there - a cheap, easy to find option for jacks. This is a bottle jack out of a full sized GM truck: Tahoe/ Pickup etc. The wrecking yards almost give them away and it's a solid jack, hight capacity with good range of...

The point of my post is the OP is asking about what to do with the rig given it’s unclean title. It would appear per your post @Jdc1 and others that this rig has gone through a lot of changes in its restoration to include different year...

to do it correctly, you really need to measure your travel from full droop to full compression. the amount of lift is only part of the equasion: some trucks stand 2" above stock but with different springs they have twice the suspension travel -...

I unpacked the parts from the zinc plater

I like the double stacked washers on the shock bushings... also looks like the shocks are almost full compression? doesn't look like anything you couldn't fix

I spent two full days searching and reading every thread on Mud related to aftermarket wheel size, backspacing/offset for my impending wheel purchase. Yep, ALL of them. Every single word of every single one. Seriously. Combined, it was about...

Progress. New gussets on frame.

Replaced dry rotted rear window rubber via city racer. Very satisfying 1:banana:job.

Im thinking the same thing - doesn’t look that bad. With a good torch, you could easily heat it up and get it perfectly straight

SWEET!

Couple of pieces of angle, some drilling and cutting and 💥 you have one

From the picture - the tailgate actually looks decent even if its flimsy