ToyotaBrah

Did a little mod to preserve that razor thin tailgate edge when transporting long things. Found some super-durable reinforced rubber edging. The upper tailgate weatherstrip seals against this when it’s all closed up. I bought more than I...

Hey Dudes, If you're in need of a Steering Rack Replacement, this video will help you get the job done. I did hear there was an extensive write-up on this forum regarding this job, something like 50 pages of it. I actually haven't seen it...

These are the next prototype. Gotta install them and beat the sh*t out of them before I list them on the site/call them production-ready. Slightly more material around the weak spot and a little larger hole for easier installation. When bolting...

In the game of inches, clearance is everything- I kinda doubt this would be the difference between making it over a rock or not but I've definitely given these bolt heads a run for their money over the last 4+ years. Less opportunity to get hung...

Cruiser Patch LCA reinforcement prototyping... I've always disliked the LCA reinforcement brackets from OME, Ironman, etc. (specifically the required drilling). The brackets I just drew up are 100% bolt-on with the option to weld them on if you...

Cruiser Patch sells one. https://www.cruiserpatch.com/products/100-series-cv-axle-puller-tool-sst

I’ve read through this thread backwards and forwards a few times and my head hurts. So many different numbers flying around. So far I’ve seen 6 “rod numbers” mentioned: 7850A - This is apparently the one for manual tilt (aka Land Cruisers)...