Supercharger users: What does your pulley/belt arrangement look like?

[00N8]

Calling all guys with superchargers, can you take a picture of the serpentine belt and show me how your pulleys are configured?

I had a strange noise and movement from my tensioner after I replaced my belt recently and want to understand what other's setups are like.

Here's the thread where I was having issues:

https://forum.ih8mud.com/100-series-cruisers/667700-help.html

Thanks in advance

 

[PoppaWheelie]

See page 24/25 lines 40/41.

http://www.lextreme.com/PDF/2UZTRD.pdf

(I found this in your Newbie Guide, very well written by the way. I have spent hours in there and in those links...)

It shows a special idler bracket. Did you get this with your kit? It also has a routing diagram.

 

[PoppaWheelie]

Or if you ended up with a newer kit you might look at line 42 over here?

https://s3.amazonaws.com/misc_n8/03-04-SC+Install.pdf

hope this helps

 

[00N8]

Guess I should have referred back to my own post!

That second idler pulley was taken off (shown next to step 41). i'm going to check with the shop tomorrow on the length. I wonder if I had the Tundra 2700 mm length belt instead of the Sequoia/LC belt.