Where do these go

[fusionworks1]

Got these parts back after paint job. Does anybody know where these go?

 

[klinetime574]

Inside the D pillars behind the vents.

They match the bolt pattern of the four screws. They just get jammed up in there and then are attached by the four screws. Through the vent then the plastic duct and then into the body.

Kinda cool little pieces. The vents on the inside are higher. They duct air down and out.

 

[SPANNERSPINNER]

Seconded. These are the rear vent tunnels (or whatever you call them) and go in the D pillar and connect the inner and outer vents. Are you missing the flappers or are they sitting underneath?

Not to hijack, but does anyone know where you can buy a set of the flappers? Everytime I wash my truck I have some water enter the interior through the d-pillar vent because the flappers are missing.

 

[klinetime574]

SpannerSpinner- You could cut some pliable rubber to fit. Somewhere around 1/16" or a couple millimeters would work perfectly. And then rivet them in place. No one would ever see them. Just as long as they work

 

[SPANNERSPINNER]

Do they just sit loose in there? Ive never seen a set in-tact.

--Allen (mobile)

 

[doug720]

I still have a couple of sets left if you need them?

https://forum.ih8mud.com/sale-parts...erhaul-silicone-rubber-replacement-flaps.html

Doug

 

[SPANNERSPINNER]

So these go at the top of the plastic vent tubes? If you have some already made Ill take a pair. How does one get the vent pipe out - just pull?

--Allen (mobile)

 

[fusionworks1]

Thanks to all who replied.