Anyone know where I can get 1 x 2 rectangular tubing bent in western Oregon?
Thanks.
Thanks.
Tubing bender in Oregon
- Thread starter Mountain Goat
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #2
Or... Does anyone know where I can get original or repro bows for a M116A2?
A flip through the yellow pages under metal fabrication/fabricator should get you close with a call or two.
Is metal tech up there?
Is metal tech up there?
- Thread starter
- #4
Thanks. I did call around. Couldn't find anyone that can bend other than round tube. One guy said I would have to go to Portland. I think that's where Metal Tech is.
They are so busy building FJ Cruiser bling, I doubt they would have time to deal with me.
They are so busy building FJ Cruiser bling, I doubt they would have time to deal with me.
KOWBOY
President
- Joined
- Mar 21, 2005
- Threads
- 209
- Messages
- 5,878
- Location
- Diggin' mud
- Website
- www.elwoodwhitetrash.com
Mark and LT are top-notch Folks that produce high quality, hardcore accessories ... and they're lifetime members of my club.
Did you call and ask if they could help?
- Thread starter
- #6
Problem solved. I'm just cutting straight sections of tube and fabbing elbows from laminated hardwood plywood. It'll be plenty strong enough to support a canvas top.