- Year
- 1998
- Vehicle Model
- 4Runner Gen3
- Location
- Rancho Cucamonga, California United States
- Mileage
- 321200
- Color
- White
hi all, looking to sell my rig and get into a LX470.
lots of maintenance work has been done on it since i bought it at 305k miles.
limited trim, 321k miles, rear locker.
looking for 15k OBO
Maintenance/mechanical:
- JDM motor at 315k (i have the papers to back the work was done at a shop)
- 5100s with 881/890
- Sway bar bushings (poly)
- Lower control arm bushings (poly)
- Upper control arms (JBA)
- Upper ball joints (Toyota)
- Lower ball joints (Toyota)
- Outer tie rods (Napa)
- Inner tie rods (Napa)
- Steering rack (Toyota)
- Pads/rotors/drums (Napa)
- Front bearings (Koyo)
- Extended travel CV axles
- Fuel filter
- AT4s with less than 10k miles
Aftermarket:
- Vidal Metal Worx F-14D bumper
- HR Woodworks sleeping platform (two pullout cabinets, 1 sliding table)
- Molle panel
- Headlight retrofit
- 4XInnovations sliders
- Sony radio unit
lots of maintenance work has been done on it since i bought it at 305k miles.
limited trim, 321k miles, rear locker.
looking for 15k OBO
Maintenance/mechanical:
- JDM motor at 315k (i have the papers to back the work was done at a shop)
- 5100s with 881/890
- Sway bar bushings (poly)
- Lower control arm bushings (poly)
- Upper control arms (JBA)
- Upper ball joints (Toyota)
- Lower ball joints (Toyota)
- Outer tie rods (Napa)
- Inner tie rods (Napa)
- Steering rack (Toyota)
- Pads/rotors/drums (Napa)
- Front bearings (Koyo)
- Extended travel CV axles
- Fuel filter
- AT4s with less than 10k miles
Aftermarket:
- Vidal Metal Worx F-14D bumper
- HR Woodworks sleeping platform (two pullout cabinets, 1 sliding table)
- Molle panel
- Headlight retrofit
- 4XInnovations sliders
- Sony radio unit
Last edited:
