Some questions

[craptacular]

I did not want to start 6 new topics so....

Where in Anderson can I get my 36in TSLs balanced? No, I have not asked around at shops yet.

I have a skull and crossbones aluminum winch fairlead. It will not fit on the front of my 40. Does anyone want to trade me for just a regular aluminum fairlead? If not, I am going to cut the bottom part off of this one.

Has anyone around here turned their springs around on their 40 to increase the wheel base? I would like to see one and compare. Was it worth doing?

My roll cage is bent from where the x2 previous owner rolled the 40 over. I dont know if he went all the way over, I think he just flopped it over on its side. Not smashed in or anything, just pushed over to the driver side alittle. Can this be fixed or does it NEED to be replaced?


That is all for now I think. Thanks.

 

[Southeast Overland]

Ralph Hayes Toyota could probably balance (or attempt to balance) to TSLs.

How bad is your cage? If you just want to wheel your 40 "close enough" probably = "good enough." Now if you want to put a hardtop on that might be a little trickier. You should check to make sure your cage is still structurally sound before you 'test' it again. Once metal is bent it becomes weaker. It has been bent once, then you bend it at least one more time to try to straighten it = weaker even more. Someone else can probably chime in with better info.

Oh, and check w/ Hard40 about the springs. There are a bunch of pics floating around MUD of this. It doesn't look like stock but I like it and it works better on the trail.

I did not want to start 6 new topics so....

Where in Anderson can I get my 36in TSLs balanced? No, I have not asked around at shops yet.

I have a skull and crossbones aluminum winch fairlead. It will not fit on the front of my 40. Does anyone want to trade me for just a regular aluminum fairlead? If not, I am going to cut the bottom part off of this one.

Has anyone around here turned their springs around on their 40 to increase the wheel base? I would like to see one and compare. Was it worth doing?

My roll cage is bent from where the x2 previous owner rolled the 40 over. I dont know if he went all the way over, I think he just flopped it over on its side. Not smashed in or anything, just pushed over to the driver side alittle. Can this be fixed or does it NEED to be replaced?


That is all for now I think. Thanks.