Should I switch to 4:11?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 18, 2006
Threads
313
Messages
2,096
Location
Alabama
A guy on the forum lives nearby me and has PMed me. He said that he has a set of 4:11s on his fj40 and says that he may want to trade with my 4:88s. Should I go with it? Will the 4:11 work nicely with my 35" tires. What is the down side and good side (pros and cons). Could I put bigger tires on it in the future?
 
badass said:
A guy on the forum lives nearby me and has PMed me. He said that he has a set of 4:11s on his fj40 and says that he may want to trade with my 4:88s. Should I go with it? Will the 4:11 work nicely with my 35" tires. What is the down side and good side (pros and cons). Could I put bigger tires on it in the future?




Lets start with this:



How do you intend on using the truck?


Pavement pounder?


Or will you be using this off road, and if so, how?
 
If your answer to Poser's questions are that you're going to use the cruiser for moderate to serious off-road use, then what transmission do you have? I have 4:11's with 35's. I have an SM420 and the 3-speed case and that combo works great. Although I am going to go with dual t-cases soon. :D
 
Well see I know I won't ever go above 35s. I'm actually thinking of downgrading to 33s. However the 4:88s are not allowing me to go the speed i want. It is going to be a daily driver (my only car). I can go 70 right now but my rpms are so high, 3300-3500. Not going to work for me. I will be doing 80% on road 20% offroad. That is an estimate because I am a student right now. Either way I want to be able to go highwy speeds without pushing the motor and want to offroad with ease. I'm in alabama, not much rock climbing. I'm not going to abbuse the rig. But will take it on trails. Also, for resale, would the buyer rather have 4:88s or 4:11s? All that being said, should I switch to the 4:11s?
 
I have 4.88s and Q78-15 tires (about 35.5) and those gears are too tall for the highway. I sized the gears using 37s...then I got rid of the mtrs (which were never 37 inches tall) and went with the Q78's. I don't trailer my vehicle, so it has to do highway time to get to the trail. I will probably go with 4.11s and a Marlin at some point.

4.56s and 35s is about right, but 4.11s are much easier to find.
 
What ever you do make sure you find someone who will just change chunks out with you it might also be in your best interest to look for fine spline 4.11s. Your 4.88s already installed in a chunk and being fine spline are probably more desirable than 4.11's you can get those anywhere. Whatever 4.11's you trade out for make sure they are in good shape. That way it's just swap plug and play.

I run 35's and 4.11's don't expect the power to be as good as the 4.88's but they are great on the road and do well with mud and some rocks.
 
badass said:
If I have arb in the rear, can i still swap the 4:88s for the 4:11s and keep the locker?

Yes, but only if you swap gears on to your ARB carrier, which is going to cost you some money to do.

My 2 cents:

Keep the 4:88s and 35s if you ever go off road or get larger tires if you really need to go faster than 70.

If you don't wheel it, sell the 4:88s and ARB and get stock open 4:11s. You should get a lot more money for the 4:88s and ARB.
 
This topic is of interest to me as well. Not that I am looking to switch, but more for education purposes.

I currently have:

33's
4.11 (so the PO claimed)
4 speed
3 speed t-case
detriot locker in rear

Q1: When it comes to the road, I find I can hit 70 mph - but to do so I am at like 3800-4000 rpms - seems super high. I generally hang out around 60-65 mph at around 3300-3500 rpms. To you guys, does this high rpm+speed fall in line with the PO's claimed 4.11 stock gearing with rear locker? or could there be something else (as he was generally clueless I have found).

Q2: how do you determine what type of transmission you have: SM420.....
 
PabloCruise said:
When you say to hit 70 it takes 3800 RPM< do you mean hitting 70 on your speedo, or actually moving 70 MPH

I meant to maintain 70 once I get there... (which is a little sketchy in a no door having, open top sporting, squirrely steering feeling rig).
 
ah.....

actually, I meant 65 on my speedo which I translated to 70 traveling speed in this thread. so, for all intents and purposes... it would still be 70 then, no?

this is based on some tests I have done in the past year against one of those radars the sheriff leaves in your neighborhood. drive at it at 30 on the speedo and the radar says 35 for example.. so I always just keep in mind 5 mph diff between real world and speedo.
 
Q2: how do you determine what type of transmission you have: SM420.....

Do you have a granny gear? sm420 will have a bulge on the output side, the clearances between the bluge and the front output are very tight, actully interference fit untill grinding is done. You will also have some sort of adapter between the tranny and t-case, either a 3/4" one or the ~6" AA one, this is of coarse you still have a toyota case, do you really not know what your drivtrian is?

and oh, 2700 ~ 70mph with 37s and 4.10s it is nice
 
Back
Top Bottom