New member to family (1 Viewer)

[REKCUT]

Finally

 

[REKCUT]

Out and about

 

[71fj40cruiser]

Thad, here is what I have found.


Here are the 5 locker wires that are missing in the large body harness of a non-locker Land Cruiser. It's been reported that all LX450s have a harness with the wires included.

These should to be at least 14ga:
ID1 pin 3 <--> BQ1 pin 2
ID1 pin 10 <--> BQ1 pin 1

These can be 18ga:
ID1 pin 9 <--> BQ1 pin 6
ID1 pin 13 <--> BQ1 pin 12
ID1 pin 14 <--> BQ1 pin 5

Connector ID1 is in the driver's kick panel. You will probably need to remove the ABS ECU to get to it. Connector BQ1 is the driver's quarter panel. You may need to remove the jack holder to get to it.

 

[REKCUT]

Less than a week to big bend trip. Almost finished. Still need sliders put on, spare, and antenna. Locker wiring, snorkel will have to wait til after trip is finished.

 

[REKCUT]

Wiring harness out. Now to put it back in