I broke a driver side birf yesterday, inner and outer destroyed and the spindle is a wreck. Anybody got a stock fine spline laying around until I get another chromo?
Thanks,
Chris
Thanks,
Chris
Need parts (1 Viewer)
- Thread starter slvrbck
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I have em for the 60 series...
ONE of the two will match the 40. Not sure which one though.
K
ONE of the two will match the 40. Not sure which one though.
K
BTW...
NICE WORK THROTTLE BOY!!!!!!
NICE WORK THROTTLE BOY!!!!!!
- Thread starter
- #4
The birf will def work, but i'm not sure which inner will cross over. i just need something to throw in until the new chromos get here.
Bad thing is, I wasn't even in the throttle...you don't need it in that rig. i was slightly turned, no hard flex, no hard stress, let the clutch out and it snapped!!
This was about 2 seconds before it broke. The pic of it 3 wheeling was right before I sat it down and repositioned. The rear dif was hung a little bit, so i backed up to hit a foot or so over, and then SNAAAAAP!! WTF??
Bad thing is, I wasn't even in the throttle...you don't need it in that rig. i was slightly turned, no hard flex, no hard stress, let the clutch out and it snapped!!
This was about 2 seconds before it broke. The pic of it 3 wheeling was right before I sat it down and repositioned. The rear dif was hung a little bit, so i backed up to hit a foot or so over, and then SNAAAAAP!! WTF??
- Thread starter
- #5
Oh, and BTW, this crap happened on Steve's Loop at the easy part of the trail, it is kinda ridiculous....63 rigs went thru there yesterday, and 2 of the most well built broke shafts. Jesse broke a Branik D60 shaft, and I broke a birf/inner axle. He was playing around in an offshoot canyon and I was simply pulling up a dang hill....