The past few years training has been hard on my Maxtrax. The traction teeth have melted off two of the 4. Maxtrax makes replacement teeth for the extreme boards and figured these were no longer under warranty so I would try to get a little more life out of them.
I first cut the melted plastic off with a oscillating tool, then filed flat, center punched and drilled a pilot hole, then drilled a 9/16" hole. Next I pushed the extreme traction tooth in and threaded them in with a torx bit.
This is not an approved repair by Maxtrax, used car buyer beware your mileage may vary! I will report back as to how durable this repair is. If you'd like to see videos go over to my social media, Instagram backroad4wdtraining
I first cut the melted plastic off with a oscillating tool, then filed flat, center punched and drilled a pilot hole, then drilled a 9/16" hole. Next I pushed the extreme traction tooth in and threaded them in with a torx bit.
This is not an approved repair by Maxtrax, used car buyer beware your mileage may vary! I will report back as to how durable this repair is. If you'd like to see videos go over to my social media, Instagram backroad4wdtraining