Looking for: Late FJ60/62 transfer case and front driveshaft

[YotaJosh]

I'm on the hunt for a late version FJ60/62 "splitcase" transfer case. The later versions had 38mm idler shafts instead of 34mm.

I'm also looking for a stock front driveshaft for a 60/62. An 80 shaft might work if anyone has one laying around, but it needs to not have a CV/Cardan joint.

 

[YotaJosh]

Bump before I start looking out of state.

 

[Doable]

Do you have a measurement of the drive shaft from flange to where the slip yoke starts for the splines or fully compressed?

 

[YotaJosh]

Length is really not that important. I have a 350/700R4 so its custom anyways.