Leveling Kit Question

[arodweb]

I had this leveling kit installed today and my FJ came out not evenly leveled. the kit is 3" in the front and 1.5 in the back......the end result was that the front was lower about 1" less than the back

Any thoughts??, and thank you for any help

 

[Mtbcoach]

Not sure of the question.

Is it that its not "level"? Are you looking for the same amount of space in the fender wells and are measuring from the ground to the lip of the fender flare?

I'm probably stating the obvious, but make sure you are measuring both sides (driver/passenger), on a level surface and accounting for the gas tank being full or not as well as any additional weight you may have in the rig. All those can impact a "level" measurement.

Sounds like you just need to take the rear spacer out and see where that gets you...

 

[arodweb]

Not sure of the question.

Is it that its not "level"? Are you looking for the same amount of space in the fender wells and are measuring from the ground to the lip of the fender flare?

I'm probably stating the obvious, but make sure you are measuring both sides (driver/passenger), on a level surface and accounting for the gas tank being full or not as well as any additional weight you may have in the rig. All those can impact a "level" measurement.

Sounds like you just need to take the rear spacer out and see where that gets you...

thanks for the reply...

I did measure both passenger/driver and they're both the same. I have a full tak of gas btw. The front is 1" lower than the back. I wonder is it was not installed right