kenwood DNX5120 6.1 Stereo/Nav unit. 80 series and others

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 26, 2006
Threads
90
Messages
1,774
Location
San Antonio.
SOLD!

I have one Kenwood DNX5120 for sale, $300 plus shipping. Replacing it with a slightly newer model. This one was purchased new two years ago from Crutchfield. This model works great in an 80 series and I can offer some step by step install advice if needed. However it should work with any vehicle having space for a double din radio. Comes with basic Kenwood wiring harness, generic Toyota wiring harness, GPS antenna, mounting cage, trim plate and users manuals (Radio head unit and Garmin GPS, and installation manuals (Kenwood and Crutchfield). Accepts USB musics inputs as is and is expandable for ipod, bluetooth, sirus/xm radio, rear camera, remote control, etc. Check out features here: Kenwood DNX5120 Navigation receiver at Crutchfield.com
 
Last edited:
All PM's replied to.
 
Updated to include the extra generic Toyota wiring harness that is still new in the wrap as well as the Kenwood and Crutchfield installation manuals that I found.
 
All PM's replied to.
 
How does this tie into the stock "amp" setup? Does the harness allow plug and play with all the speakers and "sub" to work on a 97 LX450?
 
I ran it in my lx450 with the factory amp intact but had to add in-line RCA filters to eliminate engine hum. You can do it that way but you need a different harness and filters. If the buyers plans to use the generic Toyota harness I am including you would need to bypass the factory amp. I was going to install it that way until I found the RCA filters that cut out the hum.

Also, I'm in Fort Rucker.
 
Sale pending.
 
:crybaby: Crap that's what I get for going on vacation. :hillbilly:

If it falls thorugh for some reason send me a PM.
 
SOLD!
 

Users who are viewing this thread

Back
Top Bottom