HAC Valve for 84 FJ60???

[Brock]

Does anyone have an HAC Valve laying around from a desmog they would like to part with that works. Mine works but was changing out my vacuum lines and got to last two lines and one of the nipples popped off of the HAC.

It is one of the air inlet lines not an actual vacuum so going to super glue, seal with silicone and then see if that works in meantime...hopefully it wont affect performance much since I am at sea level. It is a discontinued part so none of the dealerships have them so hoping one of you guys that did engine swap or desmog has your old parts still.

PM me if you do with cost and shipping so I can get it in mail to me tomorrow...thanks a bunch.

if not I might be getting a Trollhole carb and desmog the whole damn thing....shame to waste all this brand new pretty blue vacuum line though. LOL

 

[Southeast Overland]

I've got some random smog parts laying around from a 60. What does this sucker look like?

 

[Brock]

it is black body with brown top....one large hose out of bottom area.....four small vacuum line ports on top portion.....pipes are in diamond pattern with one on top...two under it on either side...then another under it in middle...then 5.5mm hose on lower portion.

 

[Brock]

the top three ports are air inlets per emission service manual...fourth one is the only vacuum...then the bottom is for air exit.

 

[Southeast Overland]

I think that's a 10-10. I'll rummage through my stash tonight and see if I have that I don't think so.

 

[Brock]

Part number 25709-61010

 

[Carp]

I'm 90% certain I have it in the garage, I'll check after work...

 

[Southeast Overland]

I checked and I don't have one.

 

[BELMONT148]

You can have the one off my brothers if you tell me where to look for it. If it is mounted on the motor it is in a pile of desmog parts, if it is on the fender, firewall, etc. then it is still on the truck disconnected.

LMK,
Jeremy

 

[Brock]

It is mounted in a series of brackets off firewall on drivers side...slightly forward of the carb. There are a bunch of vacuum lines coming off of engine area with four on top and then more stacked tightly under them....the top ones lead to the HAC Valve. It is only black body and brown top plastic device with vacuum lines attached near fenderwell...Page 15 in 2F emissions manual.

so between diagram and picture should be easy to identify...

 

[Brock]

I'm 90% certain I have it in the garage, I'll check after work...

what is the prognosis?

 

[Brock]

I checked and I don't have one.

what good are you?

 

[dbenke]

Damn, that's alot of vacuum lines......part of the reason I got a 62

 

[Brock]

but mine are all blue and pretty now...

 

[Carp]

what is the prognosis?

The prognosis is unclear. I moved all that stuff to storage and forgot, so Sat. I'll run over there and look. Sorry for the delay.

 

[Brock]

Thanks to RedFishBlueGrass who is a local Fj60 owner but not yet a club member...I have the HAC Valve in my hands. I had a good visit with him during lunch and was able to compare rigs...and check out the carb he bought from Trollhole for desmogged Land Cruisers.....very nice.

He is looking for a set of tires so told him DBENKE might have some available when he gets his new ones....or if anyone else has a set of 15" tires....

Thanks again and will be putting this bad boy on tonight.....c a r e f u l l y!