fitting 35s on the 80 (1 Viewer)

[peepers]

randy had already installed OME heavy springs all the way around which lift the truck about 2.5" i think. I just ordered 1" spacers for the front, 2" bump stops for the rear and extended stainless brake lines to run from the fram to the axles.

also got the caster plates.

this should take away the slight rubbing at full flex.

next? need to find precision gears!

 

[82cruiser]

Sounds great Pete. Let me know when I can buy it back from you.

 

[Sporin]

Did you get out to Miller Time yesterday or was that this coming sunday you were looking to wheel?

 

[peepers]

this coming sunday!

Randy, you cant have it back! just getting it dialed in. The center diff lock switch is finally in. Going to do the 7 pin mod as soon as i get the correct tools. got the air compressor hooked up today.

and

i am going to get a new rear bumper from iron pig offroad along with the tire carrier. will you help me install it? its bolt on but we have to cut the current one off...

 

[82cruiser]

Sure thing! Let me know when it comes in and we'll make it happen. You can ebay the old one and sell it as a boat anchor.